Save over 60% on a Seneca Woodworking "Big Dawg Kit"!
Want to square up your guide rail with your MFT? Our Rail Dogs have you covered.
Our 40mm Rail Dogs provide enough height to locate your guide rail on your MFT table or work surface and provides more clearance for the saw motor to allow a deeper cut.
Our 70mm Rail Dogs are great for positioning your guide rail in preparation to make a cut. Their height allows you to locate your guide rail on thicker stock in preparation for a cut.
Want to locate stock or secure a custom fixture to your MFT? Three different lengths of our Standard Threaded Dogs will make that possible.
Small (17mm) Threaded Bench Dog
These are a standard bench dog that protrude 17mm deep into the work surface, allowing you to secure it with a clamping knob in 18mm or thicker stock. Threaded the whole way through, this allows attachment of other accessories to the top with M8 bolts or clamps.
Medium (24mm) Threaded Bench Dog
This is a slightly longer version of the Short Tri-Groove Bench Dog that has 24mm of dog protrusion, useful for thicker work surfaces.
Large (30mm) Threaded Bench Dog
This is a version of our Tri-Groove Bench Dog with 30mm of dog protrusion. These dogs are useful for joining multiple work surfaces together or attaching jigs an fixtures to the top of your work surface.
Do your Dogs keep running away when you need them most? Stowaway Dogs are always on hand to locate stock.
Stowaway Dogs feature a T-shaped feature in the bottom that allows you to stow them on the side of your MFT table in the T-slot, allowing you to keep your dogs out of the way when you don't need them but handy when you do.
Need an extra surface to put that project you're painting or finishing? Our Paint Point Dogs will speed up the finishing process.
Paint Point Dogs provide a fine point that can be used to support a finished work piece being painted. This point ensures minimal contact with the work piece to prevent damage to the finish. These dogs also have a M8 thread on the underside so they can be secured to your MFT table or other work surface with a bolt or clamping knob.
Need to keep your project from sliding around? Want to elevate a piece of stock off your MFT to protect its surface during a cut? Our Rubber Grip Dogs will do that.
With two sizes available, our Small and Large Rubber Grip Dogs have a few tricks up their sleeve. These dogs function as low profile bench dogs and can be used as a horizontal dog stop to prevent thin materials from sliding on your work surface. They are topped with a rubber grip pad that can support a finished work piece above your work surface while protecting it from damage.
They also work as MFT surface protectors. These dogs elevate your workpiece above the surface enough for the saw blade to cut all the way through without damaging the top of your work surface.
Large Grip Dogs include threaded M8 holes on the bottom, allowing attachment to the work surface with a bolt or clamping knob.
Want to secure your workpiece? Clamp Dogs will take care of that.
This combination bench dog and clamp mounting plate designed for the Festool MFT table allows you to take advantage of the grid of holes in your table to make precise cuts. The clamp mount portion is pre-drilled with mounting holes that allow you to attach either a Kreg Automazz Bench Clamp or a Bessey Auto-Adjust Toggle Clamp for quick, accurate clamping of your workpiece.
Need a solution to hold dowels in place? Round Stock Dogs can do that.
Round Stock Dogs feature a V-shaped groove designed for holding round stock objects on your MFT. They are also useful for supporting square stock by a corner. M8 threads on the bottom allow you to secure these dogs to your MFT or other work surface, or they can be used to build custom fixtures.